Each manufacturer has different product models and parameters. Therefore, when choosing a pipe fitting hot melt welding machine, you should choose a new automatic pipe fitting hot melt welding machine that supports manual and barcode dual-use, otherwise you can purchase other products that will be useful during use. Reduce, thereby reducing the efficiency of use, causing unnecessary waste,

During construction, 2.5mm² input cable is generally required when the power source is within 50 meters of the welding machine, and so on, the longer the distance, the greater the cable voltage used, when the grid voltage does not meet the requirements, this time must be selected Generator to support power supply. There are strict requirements when using the pipe fitting hot-melt welding machine. It must be used by professionals and certified personnel. Non-professionals should not be close to avoid unnecessary danger to the operators.

 

The control box of the pipe fitting hot-melt welding machine is connected with a pressure sensor and a temperature probe, which can control and adjust the temperature of the heating plate, and also control the preheating stage, heat absorption stage, conversion stage, welding stage, and cooling stage during the welding process. Time parameters. During work, different pressures and maintenance times are allowed to be set and recorded at each stage. Each work cycle can be automatically recorded and repeated operations. A new set of welding parameters is selected. If the actual parameters are out of tolerance, an alarm will appear.

 

The automatic pipe fitting hot-melt welding machine can achieve consistent, reliable and repeatable operation; the system will control, monitor and record the main parameters of each stage of the welding process to judge the status of each weld; the welding machine has a data retrieval and storage device and The data download interface can store and download welding data; after milling the end face of the pipe, it can automatically check whether the pipe is clamped firmly; automatically measure the drag pressure and automatically compensate the drag force.

 

Automatically monitor the temperature of the hot plate according to the selected parameters. Only when the temperature of the hot plate is within the set operating temperature range, the welder can perform welding; the hot plate is placed in all stages (pressurization, crimping, crimping, The pressure drops to drag pressure, heat absorption pressure and time, switch: frame opening/hot plate extraction/frame closing, pressurization, pressure retention, cooling) automatically; the microprocessor adopts a closed-loop control system.